Norstar

There are a couple of different ways access the time change feature, depending on the type of system you have.  A programming template is provided below if you need it.   Just cut-out the shaded areas as well as around the outside of the template.   Once cut, place the template over the top 2 rows of buttons on your 7310 or 7324 telephone (typically lines 1 and 2 on your telephone).

After you enter programming mode, all methods are pretty much the same.

Access type 1:   Press  * * TIME (8463)

Access type 2:   Press  * * ADMIN (23646)

System displays Password & enter 23646

Display shows 1.Sys speed dial

Press Next Display shows 2. Names

Press Next Display shows 3. Time and date

Press Show Display shows Time 16:24

On the Softkey under the display it says CHANGE

If you wish to change the time, press CHANGE, if not press NEXT

Once you pressed the CHANGE button the hour displays;

If you wish to change the hour, press CHANGE, if not press NEXT

Once you pressed the CHANGE button the hour is erased allowing you to enter the new time - enter the new hour in 24 hour format, when OK press NEXT

Once you pressed the NEXT button the minutes display;

If you wish to change the minutes, press CHANGE, if not press NEXT

Once you pressed the CHANGE button the minutes are erased allowing you to enter the new time - enter the new minutes, when OK press NEXT

Follow the same procedure for changing the date!

Programming template

protemplate.bmp (147614 bytes)

Print this page, cut out the shaded areas with a utility knife and then cut around the outside box.  After you're done cutting, place the template over the top 2 rows on your 7310 or 7324 telephone.

 

Norstar Startalk - Adjust Time and Date
* Note Norstar Voice Mail R. 4 sets its time automatically from the telephone system

1) Press Feature 984
2) Enter the system administrator mailbox and password combination
3) Press OK
4) Press Change
5) Enter < the year, month, and day > NOTE: this is a six digit field. Any single digit month or day must be preceded by a zero. For example February 7, 1991 must be entered as 910207.
6) Press Next The display changes to show the time
7) Press CHNG The display shows Enter hhmm:
8) Enter the < the time in hours and minutes>Note: This is a 4 digit field. Any single digit hour or minute must have a zero preceeding the number. For example, 2:03 must be entered as 0203.
9) Press AM or PM
10)  To end the session press Rls